Woodclean

Preparation is key to a beautiful, long-lasting timber finish.

Renovating or rejuvenating your timber can be easy, but without the right preparation, it will prove difficult. Feast Watson Woodclean is the perfect product to ensure you are prepared for your renovating journey.

Woodclean is a powerful, oxalic acid-based preparation treatment that aids in the removal of oils, mould, stains, and tannins from new and weathered timber. Without removing these surface contaminants, your timber may discolour or impede the absorption of potential coatings.

Woodclean is perfect for restoring decking, outdoor furniture, fences, pergolas, and other exterior woodwork for grey and weathered timber.

Don't fault before you even start, use Feast Watson Woodclean to ensure your timber is looking its best.

Safety Data Sheet

Find a stockist

WHERE TO USE

Cleaning any exterior timber

COVERAGE RATE

20m² per litre

RECOAT TIME

When completely dry

DRY TIME

Approx 20 Minutes

CLEAN UP

Water

SIZES

1L, 4L

MIX RATIO

1 part Woodclean to 4 parts water.

How to prepare your timber for Feast Watson Woodclean:

Just sweep down your surface and thoroughly wet down with water.

How to apply Feast Watson Woodclean:

Dilute Woodclean in water by mixing 1 part Woodclean to 4 parts water. Make sure to stir your diluted mixture thoroughly!
Using a stiff bristle brush or broom, apply Woodclean to dampened timber and scrub surface vigorously.
Go make yourself a coffee and allow the Woodclean solution to penetrate the surface for 20 minutes.
After 20 minutes has elapsed, rinse with high pressure water.
Allow the surface to dry completely before applying further products.

Note: Protect nearby paint, plants, and other surfaces with plastic sheeting, or wet them first and rinse immediately after. Woodclean may cause erosion of some timber sealants and fillers so be sure to test surface prior to application.

How to maintain your timber after using Feast Watson Woodclean™:

Monitor your timber for a buildup of dirt, grime, and mould.
When required, simply apply Woodclean™ as per the application instructions.

Say hello to squeaky clean timber!

Traditional Timber Oil

Traditional Timber Oil

A natural Timber Decking Oil to nourish and protect outdoor timber available in 3 muted tones.

Wet Look Decking Oil

Wet Look Decking Oil

A gloss finish deciing oil with the benefit of easy water washup.

Timber & Deck Stain

Timber & Deck Stain

The Timber and Deck Stain will achieve a rich colour and subtle sheen to your timber, providing a new and modern look to your timber and outdoor area.

PREPARATION

How to prepare your timber for Feast Watson Woodclean:

Just sweep down your surface and thoroughly wet down with water.

APPLICATION

How to apply Feast Watson Woodclean:

Dilute Woodclean in water by mixing 1 part Woodclean to 4 parts water. Make sure to stir your diluted mixture thoroughly!
Using a stiff bristle brush or broom, apply Woodclean to dampened timber and scrub surface vigorously.
Go make yourself a coffee and allow the Woodclean solution to penetrate the surface for 20 minutes.
After 20 minutes has elapsed, rinse with high pressure water.
Allow the surface to dry completely before applying further products.

Note: Protect nearby paint, plants, and other surfaces with plastic sheeting, or wet them first and rinse immediately after. Woodclean may cause erosion of some timber sealants and fillers so be sure to test surface prior to application.

MAINTENANCE

How to maintain your timber after using Feast Watson Woodclean™:

Monitor your timber for a buildup of dirt, grime, and mould.
When required, simply apply Woodclean™ as per the application instructions.

Say hello to squeaky clean timber!

RELATED PRODUCTS

Traditional Timber Oil

Traditional Timber Oil

A natural Timber Decking Oil to nourish and protect outdoor timber available in 3 muted tones.

Wet Look Decking Oil

Wet Look Decking Oil

A gloss finish deciing oil with the benefit of easy water washup.

Timber & Deck Stain

Timber & Deck Stain

The Timber and Deck Stain will achieve a rich colour and subtle sheen to your timber, providing a new and modern look to your timber and outdoor area.

System.IO.IOException: The process cannot access the file 'C:\local\Temp\ExamineIndexes\87b109f06c75ad52504281172cd4c66b\ContentIndex\_1.cfs' because it is being used by another process.
   at System.IO.FileSystem.DeleteFile(String fullPath)
   at System.IO.FileInfo.Delete()
   at Examine.Lucene.Directories.SyncedFileSystemDirectoryFactory.ClearDirectory(DirectoryInfo directoryInfo)
   at Examine.Lucene.Directories.SyncedFileSystemDirectoryFactory.SyncIndex(IndexWriter sourceIndexWriter, Boolean forceUnlock, String indexName, DirectoryInfo destinationDirectory, DirectoryInfo tempDir)
   at Examine.Lucene.Directories.SyncedFileSystemDirectoryFactory.TryCreateDirectory(LuceneIndex luceneIndex, Boolean forceUnlock, Directory& directory)
   at Examine.Lucene.Directories.SyncedFileSystemDirectoryFactory.CreateDirectory(LuceneIndex luceneIndex, Boolean forceUnlock)
   at Examine.Lucene.Directories.DirectoryFactoryBase.Examine.Lucene.Directories.IDirectoryFactory.CreateDirectory(LuceneIndex luceneIndex, Boolean forceUnlock)
   at Umbraco.Cms.Infrastructure.Examine.ConfigurationEnabledDirectoryFactory.CreateDirectory(LuceneIndex luceneIndex, Boolean forceUnlock)
   at Examine.Lucene.Directories.DirectoryFactoryBase.Examine.Lucene.Directories.IDirectoryFactory.CreateDirectory(LuceneIndex luceneIndex, Boolean forceUnlock)
   at Examine.Lucene.Providers.LuceneIndex.<>c__DisplayClass1_0.<.ctor>b__0()
   at System.Lazy`1.ViaFactory(LazyThreadSafetyMode mode)
   at System.Lazy`1.ExecutionAndPublication(LazyHelper executionAndPublication, Boolean useDefaultConstructor)
   at System.Lazy`1.CreateValue()
   at System.Lazy`1.get_Value()
   at Examine.Lucene.Providers.LuceneIndex.GetLuceneDirectory()
   at Examine.Lucene.Providers.LuceneIndex.IndexExistsImpl()
   at Examine.Lucene.Providers.LuceneIndex.IndexExists()
   at Examine.Lucene.Providers.LuceneIndex.EnsureIndex(Boolean forceOverwrite)
   at Examine.Lucene.Providers.LuceneIndex.get_IndexWriter()
   at Examine.Lucene.Providers.LuceneIndex.CreateSearcher()
   at System.Lazy`1.ViaFactory(LazyThreadSafetyMode mode)
--- End of stack trace from previous location ---
   at System.Lazy`1.CreateValue()
   at Examine.Lucene.Providers.LuceneIndex.get_Searcher()
   at DuluxGroup.CMSWeb.Services.ContentIndexQueryService.GetContentsBySearchRequestModel(String indexName, String[] includeNodeTypeAliases, SearchRequestModel searchRequestModel) in D:\a\1\s\src\DuluxGroup.CMSWeb\Services\ContentIndexQueryService.cs:line 79
   at DuluxGroup.CMSWeb.Services.ItemListingService.GetContentsByStarterNodeAndCriteria(ItemListingSource itemListingSource, IEnumerable`1 criteria) in D:\a\1\s\src\DuluxGroup.CMSWeb\Services\ItemListingService.cs:line 244
   at DuluxGroup.CMSWeb.Services.ItemListingService.GetContentInfoModelsFromChildNode(ItemListingSource itemListingSource, Int32 numberOfDisplayItems) in D:\a\1\s\src\DuluxGroup.CMSWeb\Services\ItemListingService.cs:line 140
   at DuluxGroup.CMSWeb.Services.ItemListingService.GetSortedAndOrderedContentInfos(ItemListingSource itemListingSource, Int32 numberOfDisplayItems) in D:\a\1\s\src\DuluxGroup.CMSWeb\Services\ItemListingService.cs:line 114
   at DuluxGroup.CMSWeb.Services.ItemListingService.GetViewModel(ItemListing itemListing) in D:\a\1\s\src\DuluxGroup.CMSWeb\Services\ItemListingService.cs:line 47
   at AspNetCore.Views_Partials_grid_editors_DocTypeGridEditor_itemListing.ExecuteAsync()
   at Microsoft.AspNetCore.Mvc.Razor.RazorView.RenderPageCoreAsync(IRazorPage page, ViewContext context)
   at Microsoft.AspNetCore.Mvc.Razor.RazorView.RenderPageAsync(IRazorPage page, ViewContext context, Boolean invokeViewStarts)
   at Microsoft.AspNetCore.Mvc.Razor.RazorView.RenderAsync(ViewContext context)
   at Microsoft.AspNetCore.Mvc.ViewComponents.ViewViewComponentResult.ExecuteAsync(ViewComponentContext context)
   at Microsoft.AspNetCore.Mvc.ViewComponents.DefaultViewComponentInvoker.InvokeAsync(ViewComponentContext context)
   at Microsoft.AspNetCore.Mvc.ViewComponents.DefaultViewComponentHelper.InvokeCoreAsync(ViewComponentDescriptor descriptor, Object arguments)
   at Our.Umbraco.DocTypeGridEditor.Helpers.DocTypeGridEditorHelper.RenderDocTypeGridEditorItem(IViewComponentHelper helper, IHtmlHelper htmlHelper, IPublishedElement content, String editorAlias, String viewPath, String previewViewPath, Boolean isPreview) in D:\a\1\s\src\Our.Umbraco.DocTypeGridEditor\Helpers\DocTypeGridEditorHelper.cs:line 254
   at Our.Umbraco.DocTypeGridEditor.Helpers.DocTypeGridEditorHelper.RenderDocTypeGridEditorItem(IViewComponentHelper helper, IHtmlHelper htmlHelper, Object model) in D:\a\1\s\src\Our.Umbraco.DocTypeGridEditor\Helpers\DocTypeGridEditorHelper.cs:line 222
   at CallSite.Target(Closure, CallSite, Object)
   at AspNetCore.app_plugins_doctypegrideditor_render_doctypegrideditor.ExecuteAsync() in C:\home\site\wwwroot\app_plugins\doctypegrideditor\render\doctypegrideditor.cshtml:line 4
   at Microsoft.AspNetCore.Mvc.Razor.RazorView.RenderPageCoreAsync(IRazorPage page, ViewContext context)
   at Microsoft.AspNetCore.Mvc.Razor.RazorView.RenderPageAsync(IRazorPage page, ViewContext context, Boolean invokeViewStarts)
   at Microsoft.AspNetCore.Mvc.Razor.RazorView.RenderAsync(ViewContext context)
   at Microsoft.AspNetCore.Mvc.ViewFeatures.HtmlHelper.RenderPartialCoreAsync(String partialViewName, Object model, ViewDataDictionary viewData, TextWriter writer)
   at Microsoft.AspNetCore.Mvc.ViewFeatures.HtmlHelper.PartialAsync(String partialViewName, Object model, ViewDataDictionary viewData)
   at AspNetCore.Views_Partials_grid_editors_base.ExecuteAsync() in C:\home\site\wwwroot\Views\Partials\grid\editors\base.cshtml:line 6

Footer Banner Image